Well I think I thoroughly screwed up on this on. I built a temp control unit from the 110v BIAB thread which looks like this.
While trying to get the PID to read in degrees F I was going through the settings. I came across COOL, I reset that number from 10 to 1 thinking that that was the option to change it and went to double check the PDF which took longer than 10 seconds. And it blew a fuse in the breaker box..... Reset the breaker and it will no longer turn on just keeps blowing the breaker. Is there a way to reset that back to 10? Pls help.
If i disconnect the power from the PID to the SSR do you think this will help to get it reset? Also I have searched for a good guide to get this thing setup with out much luck. Anyone know where I can go to get this thing running correctly?