Originally Posted by MaverickBrew
When doing a temp controller, what all do you need?
You need the temp controller itself,
then you need at least 1 wall replacement wall outlet
Some sort of a box to house it all in I used a standard carlon wall box for mine. This is a 2 gang, to mount the controller and the outlet.
A two gang wall plate as a cover
A power tool replacement cord, which will provide the plug to power and a few feet of extra wire to wire everything up.
Some assorted wire nuts and a screw clamp connector.
I also added a split ring rubber grommet (like we use for airlock seals on buckets) to seal the box where the temp probe comes off.
And one of the many wiring diagrams for it on this forum.
Mines a little more "hard core" it's meant to run two heat belts, two fans and still have two accessory outlets to plug stuff into....
Like my snazzy new avatar? Get Sons of Zymurgy swag, here, and brew with the best.
Revvy's one of the cool reverends. He has a Harley and a t-shirt that says on the back "If you can read this, the bitch was Raptured. - Madman
I gotta tell ya, just between us girls, that Revvy is HOT. Very tall, gorgeous grey hair and a terrific smile. He's very good looking in person, with a charismatic personality... he drives like a ****ing maniac! - YooperBrew