I am selling my stainless 1.5" Tri Clover 2-piece RIMS Tube. It comes with the following.
5 - Tri Clover Clamps
5 - Silicone Gaskets
1 - 1.5" Tri Clover X 1" NPS open Fitting (For heater element)
1 - 1.5" Tri Clover Tri Clamp X 1/4" Compression Adapter (for temperature probe)
2 - 1.5" Tri Clover X 1/2" Hose Barb fitting
This is the the model from
Brewers Hardware
I will also include two custom mounting brackets.
Does not include the heating element.
$119.00 + shipping
This item sells new as described for around $190.00 + shipping
Warnings from the Manufacturers Website.
-It is imperative that the heater element be wired by a qualified electrician, enclosed in a water-tight enclosure and protected with a FOCI circuit breaker! Improper wiring and/or control of a heater element in this environment CAN AND WILL KILL YOU. If you are not 100% sure you know what you are doing, get help. If you have any doubt, do not purchase this item.
-This device is inherently dangerous. Improperly used, dangerous pressure can quickly build in the tube resulting in an explosion of boiling liquid CAUSING EXTREME INJURY, BURNS OR EVEN DEATH!
-You must use a temperature controller to monitor the effluent temperature and control the heater element. A device that can adjust the intensity of the output such as with PID technology and an SSR are recommended. The BCS-460 or BrewTroller are two of the better qualified devices on the market. Always set the temperature below 175* to prevent the element from boiling the wort in the tube.
-You must also use a pump to move the wort across the element. A control relay must be installed that prevents the element’s control relay from closing unless the pump is operating. There are quite a few ways to accomplish this, but your system should be wired so that the element cannot energize if the wort is not moving across it. This wiring in conjunction with the temperature monitor are the only safety features preventing the element from boiling wort in the tube resulting in a dangerous build up of pressure and possible explosion.
-Each time you assemble the RIMS tube, be sure that the element is not contacting the body or thermowell of the RIMS tube. Carefully bend the element as needed to ensure the element is not contacting the tube body. ---Never use an element that cannot be installed without clearing the tube body.
-Never rotate the inlet and outlet while the RIMS tube is in operation.
If you have any doubts in your ability to install and operate this RIMS tube, don't purchase.
For Sale - Rims Tube with accessories
Linear Mode
.gif-1367621329.gif)
