Newest Threads

**zazbnf** · 12-21-2011, 12:07 AM

Quote:

Originally Posted by Malric

Im interested in the cold plate. Did you perform any temp testing? I'll need to measure my cooler when I get home.

I have not performed any temp testing. When I received it I replaced most of the fittings because most were not 1/4 flare or were 1/8 barb fittings for the soda gun, I replaced the old nasty o-rings with new nylon flare washers and pressure tested each pass using 20psi of CO2 to make sure they were not plugged and they held pressure and did not leak. It was previously used for coca-cola products, and although it looks like it was rinsed after use(not all nasty and sticky) I am sure it will need an aluminum safe cleaner and sanitizer circulated through it.

I had planned to use this for a jockey box for our homebrew club, but recently purchased an 8 tap tower on here and we are going to set that up instead for our use. I had planned to circulate the cleaner/sanitizer just prior to using it but never built the jockey box.

zman · 03-03-2012, 08:15 PM

Quote:

Originally Posted by zazbnf

I have not performed any temp testing. When I received it I replaced most of the fittings because most were not 1/4 flare or were 1/8 barb fittings for the soda gun, I replaced the old nasty o-rings with new nylon flare washers and pressure tested each pass using 20psi of CO2 to make sure they were not plugged and they held pressure and did not leak. It was previously used for coca-cola products, and although it looks like it was rinsed after use(not all nasty and sticky) I am sure it will need an aluminum safe cleaner and sanitizer circulated through it.

I had planned to use this for a jockey box for our homebrew club, but recently purchased an 8 tap tower on here and we are going to set that up instead for our use. I had planned to circulate the cleaner/sanitizer just prior to using it but never built the jockey box.

still have this?