Get your HBT Growlers, Shirts and Membership before the Rush!


Home Brew Forums > Home Brewing Beer > General Beer Discussion > No bubbles in airlock
Reply
 
LinkBack Thread Tools
Old 03-07-2013, 01:05 AM   #1
mblanks2
Feedback Score: 0 reviews
Recipes 
 
Join Date: Feb 2013
Location: , The State of Confusion!
Posts: 500
Liked 33 Times on 32 Posts
Likes Given: 40

Default No bubbles in airlock

I'm pretty sure that my primary is leaking around the seal. No bubbles from blow off tube just a small amount of condensation. Replaced with sanitized air lock, still no bubbles. I did have the bucket in a cooler area of my home basement. Room temp is 60* to 62* and I'm using Safbrew T-58 yeast however, I have a digital temperature probe attached to the outside of the bucket and insulated and it has been at 66*-67* for three days and I can smell the developing beer all around the top. The temperature is now slowly starting to drop. I'm currently at 63* - 64*.
Just looking for confirmation that it APPEARS that fermentation is completing. I will pull the top at seven days to check the SG. Just looking for thoughts.
I'll be doing primary in a carboy from this point forward. No more buckets. I want to see whats happening as opposed to guessing or removing the top.

__________________
mblanks2 is offline
 
Reply With Quote Quick reply to this message
Old 03-07-2013, 02:01 AM   #2
50calshooter
Feedback Score: 0 reviews
Recipes 
 
Join Date: Jan 2013
Posts: 10
Liked 1 Times on 1 Posts

Default

I like the buckets. Not as sensitive to light. Pull the stopper and peek in.

__________________
50calshooter is offline
 
Reply With Quote Quick reply to this message
Old 03-07-2013, 02:05 AM   #3
Revvy
Post Hoc Ergo Propter Hoc
HBT_LIFETIMESUPPORTER.png
Feedback Score: 0 reviews
 
Revvy's Avatar
Recipes 
 
Join Date: Dec 2007
Location: "Detroitish" Michigan
Posts: 40,805
Liked 2776 Times on 1660 Posts
Likes Given: 3489

Default

No more bubbles in the airlock just means that there's no more bubbles in your airlock, NOT that fermentation is done...An airlock is not a fermentation gauge, it's a vent to bleed off EXCESS gas, be it oxygen or EXCESS co2. It shouldn't be looked at as anything else, because an airlock can bubble or stop bubbling for whatever reasons, including a change in temperature (gas expands and contracts depending on ambient temps) changes in barometric pressure (You can have bubbling or suckback in the airlock, depending on pressure on the fermenter) whether or not a truck is going by on the street, the vacuum cleaner is running, or your dog is trying to have sex with the fermenter. Or co2 can get out around the lid of the bucket or the bung...it doesn't matter how the co2 gets out, just that it is.

And bubbles don't coordinate with anything concrete within the fermenter either, "x bubbles/y minute" does NOT TRANSLATE to any numerical change in gravity....if an instruction says do something when bubbles do something per something, throw the instructions out.

Fermentation is not always dynamic, just because you can't see what's going on, doesn't mean nothing is going on. And just because your airlock starts up, and then slows down or stops in a few days, doesn't mean fermentation is over YET, it just means the excess co2 is not coming out of the airlock...not that the yeast is done.

The only way to know how your beer is doing is to take a hydrometer reading, if you're worried. But not until 72 hours have gone by. Then if you're still concerned, take one...then you'll know.

Counting bubbles does not equate to anything usable in fermentation. It's not like "x bubbles/minute= y gravity points." It just means that co2 is being released....but it could also NOT be bubbling, and still fermenting away.

Relax, leave your beer alone and let it do it's thing for a couple more weeks, and most importantly, IGNORE what your airlock does or doesn't do.

In fact you might find this discussion on the superfluousness of airlocks something that will help you get a handle on this. It was started by a newer brewing who just grasped this concept.

Sounds like you still have fermentation, since you see cavitation going on with the yeast moving. Even though it's "been about a week" doesn't mean the yeast have been active for a week, if you didn't pitch enough yeast intially, and especially if you didn't make a starter for liquid yeast, it could have taken your beer 3 days to get started actually fermenting the beer, if it took three days of lag phase. Therefore you could only be on day 3 or 4 of ACTUAL fermentation.

The only way to know is with a grav reading.

__________________

Like my snazzy new avatar? Get Sons of Zymurgy swag, here, and brew with the best.

Revvy's one of the cool reverends. He has a Harley and a t-shirt that says on the back "If you can read this, the bitch was Raptured. - Madman

I gotta tell ya, just between us girls, that Revvy is HOT. Very tall, gorgeous grey hair and a terrific smile. He's very good looking in person, with a charismatic personality... he drives like a ****ing maniac! - YooperBrew

Revvy is offline
 
Reply With Quote Quick reply to this message
Reply



Quick Reply
Message:
Options
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Airlock Bubbles SandorClegane Fermentation & Yeast 2 06-04-2012 04:34 PM
No more bubbles in my airlock stevefromga2000 Beginners Beer Brewing Forum 7 06-03-2012 11:48 PM
More than just bubbles in my airlock BeerLeBaron Beginners Beer Brewing Forum 9 10-14-2011 04:00 PM
Airlock bubbles for one day only? Andini Beginners Beer Brewing Forum 3 06-23-2011 05:22 PM
Airlock - No bubbles. bobbydigital Beginners Beer Brewing Forum 5 05-17-2007 02:12 AM



Newest Threads

LATEST SPONSOR DEALS