I just converted my keg to a keggle with weldless fittings and I am about to install some copper tubing tomorrow before I brew. I am going to use 3/8 copper tube with a scrubber at the end for a hop filter. Will I be fine just to friction fit the joint coming from the tubing into the ball valve and also is there anything I need to look for in a scrubber pad for my filter. Just want to make sure my rig is going to stand up to the boil and extract the greatest amount of wort.
I know this has been hashed over many times, just wanted to revive it for some fresh answers. Thanks so much.