Icewatch

Recipes 

I am not sure if this is a new idea... kinda doubt it. However. I have recently set up a multi-tap system for a friend using soda kegs and a single co2 system. I noticed an extreme lacking in the system when not all kegs were at the same pressure when the system was set up unpressurized. Is there a backflow designed for soda kegs or is there an idea that is being secretly held in back storage for such issues? He and I are beginning to design such a prevention system and was wondering if one already exsisted.

wyzazz

Recipes 

I would suggest check-valves. There are some made specifically for this purpose.

http://stores.kegconnection.com/Categories.bok


http://www.beveragefactory.com/draftbeer/regulator/component/1600CAB_gas_shut_off_check_valve.shtml

http://cgi.ebay.com/Lot-of-10-Small-Co2-Check-Valve-Aquarium-Supply_W0QQitemZ140359279590QQcmdZViewItemQQptZLH_ DefaultDomain_0?hash=item20ae10a3e6

WenValley

Recipes 

Check valves. You can purchase the quarter turn valves for your manifold with or without check valves. Most hardware stores sell the 1/4" valves in the air compressor accessory section, those don't have check valves.

Once my kegs are properly carbed, I turn off the pressure at the manifold by shutting off the valve. I leave everything connected, and just bump the pressure when the keg needs more CO2.

Good Luck...

__________________

'A government big enough to give you everything you want, is strong enough to take everything you have.'

Thomas Jefferson