HBT 2015 Big Giveaway - Enter Now

Huge Supporting Membership Discounts - 20% Off

Home Brew Forums > Home Brewing Beer > Recipes/Ingredients > All Grain Märzen/Oktoberfest Recipe Thoughts?
Reply
 
LinkBack Thread Tools
Old 09-28-2012, 01:36 PM   #1
methodbeer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Dec 2010
Location: Raleigh, NC
Posts: 17
Liked 2 Times on 2 Posts
Likes Given: 1

Default All Grain Märzen/Oktoberfest Recipe Thoughts?

I'm planning on brewing a Märzen next week, and was hoping I could get some feedback on my first Märzen lager recipe.

Batch Size: 10 Gallons
Est. OG: 1.058
IBUs: 24.6
Color: 10.1 SRM

Efficiency: 70%

Grain Bill:
9# Pilsner (39.1%)
9# Vienna Malt (39.1%)
3# Munich Malt (13%)
1# Melanoiden Malt (4.3%)
1# Crystal 80 (4.3%)

Single Infusion Mash @ 153º for 60'

Hop Schedule (90 minute boil):
1.75oz Mt. Hood [6% AA] @ 60'
.5oz Tettnang [4.5% AA] @ 60'
.25oz Mt. Hood @ 15'
.25oz Tettnang @ 10'

Yeast: Bavarian Lager (Wyeast #2206)

Notes: I'm most likely using untreated (but filtered) Raleigh water. It seems to be high in temporary hardness.

Also, we usually do a fly sparge, but debating a batch sparge this time. BeerSmith is telling me to do 4 steps: Drain MLT, sparge 3.09 gallons, sparge 3.09 gallons, sparge 3.09 gallons w/ 168º. Thoughts on this would be helpful? The reason for the possible switch is 1) Maybe save time? 2) We're going to upgrade our system in the near future which will require a batch sparge (long story) and we'd like to practice--although 10 gallons is a lot to screw up. 70% efficiency is based on our typical fly sparge.

Thanks!

__________________
methodbeer is offline
 
Reply With Quote Quick reply to this message
Old 09-28-2012, 09:15 PM   #2
slarkin712
HBT_SUPPORTER.png
Feedback Score: 0 reviews
 
slarkin712's Avatar
Recipes 
 
Join Date: Sep 2011
Location: St. Louis, MO
Posts: 772
Liked 48 Times on 44 Posts
Likes Given: 6

Default

Regarding the batch sparge, I think it should be a huge time saver. I'm not sure about your 4 steps though. I calculate my mash-in and sparge water some that both yield the same volume. So, you mash-in with .5*(pre-boil volume) + (water absorbed by grain) + (dead space in mash tun). Then sparge/mash-out with .5*(pre-boil volume). Here's the steps I do:
1) Mash-in, mash for 60-90 minutes
2) drain mash tun to kettle
3) Add sparge/mash-out water
4) Drain mash tun to kettle

I usually start to heat my boil kettle after the first runnings, so I can get to boiling not long after the second runnings.

EDIT: You may end up with a mash that is a little thin this way. To avoid this I use the batch sparge calculator here: http://onebeer.net/batchspargecalc.shtml

__________________
slarkin712 is offline
 
Reply With Quote Quick reply to this message
Old 09-28-2012, 10:16 PM   #3
BigEd
Feedback Score: 0 reviews
Recipes 
 
Join Date: Nov 2004
Posts: 2,424
Liked 131 Times on 114 Posts
Likes Given: 23

Default

Just say no to that crystal 80. I'd also nix the melanoiden or at least drop it way back.

__________________
BigEd is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 03:58 AM   #4
methodbeer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Dec 2010
Location: Raleigh, NC
Posts: 17
Liked 2 Times on 2 Posts
Likes Given: 1

Default

Quote:
Originally Posted by BigEd View Post
Just say no to that crystal 80. I'd also nix the melanoiden or at least drop it way back.
BigEd, what's the reason for no Crystal 80? Would Caramunich be better? Or is the combo of it + melanoiden that is bad?

Also, I had read many instances where melanoiden malt was good to add if you weren't doing a decoction mash. Is this wrong? In this case, I have 1# for 10 gallons, which I thought was already pretty scaled back. Do you have insight I'm missing?

My preference is for the rich maltier versions of Märzen, like Hacker Pschorr.

Slarkin712, thanks for the info on the batch sparge.
__________________
methodbeer is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 04:16 AM   #5
BigEd
Feedback Score: 0 reviews
Recipes 
 
Join Date: Nov 2004
Posts: 2,424
Liked 131 Times on 114 Posts
Likes Given: 23

Default

Quote:
Originally Posted by methodbeer View Post
BigEd, what's the reason for no Crystal 80? Would Caramunich be better? Or is the combo of it + melanoiden that is bad?

Also, I had read many instances where melanoiden malt was good to add if you weren't doing a decoction mash. Is this wrong? In this case, I have 1# for 10 gallons, which I thought was already pretty scaled back. Do you have insight I'm missing?

My preference is for the rich maltier versions of Märzen, like Hacker Pschorr.

Slarkin712, thanks for the info on the batch sparge.
Melanoinden malt does not equal a decotion mash. Crystal 80 is just out of place in an Oktoberfest. A brew like Hasker-Pschorr Oktoberfest is going to highlight the base malts of Vienna and Munich not crystal malts. An American version of an Oktoberfest (perhaps an oversimplification but think Sam Adams) is going to be heavily influenced by specialty malts as opposed to Hacker-Pcshorr or Ayinger which is going to be biased to the base malts of Vienna & Munich.
__________________
BigEd is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 03:30 PM   #6
methodbeer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Dec 2010
Location: Raleigh, NC
Posts: 17
Liked 2 Times on 2 Posts
Likes Given: 1

Default

BigEd, thanks for the explanation. I appreciate the help. I definitely don't want to taste like Sam Adams.

I wonder if I swap the amount of Munich malt with Vienna malt, if I could achieve the darker color. Or go for 6# of each and 9# Pils. Would you suggest that? I didn't think the melanoiden was a 1:1 for decoction mash, but I figured it'd boost the maltiness, add some color, and give it some of the caramelization that I might miss in not doing a decoction. I am doing a 90' boil, so perhaps there'd be enough from that alone.

__________________
methodbeer is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 04:05 PM   #7
BigEd
Feedback Score: 0 reviews
Recipes 
 
Join Date: Nov 2004
Posts: 2,424
Liked 131 Times on 114 Posts
Likes Given: 23

Default

Quote:
Originally Posted by methodbeer View Post
BigEd, thanks for the explanation. I appreciate the help. I definitely don't want to taste like Sam Adams.

I wonder if I swap the amount of Munich malt with Vienna malt, if I could achieve the darker color. Or go for 6# of each and 9# Pils. Would you suggest that? I didn't think the melanoiden was a 1:1 for decoction mash, but I figured it'd boost the maltiness, add some color, and give it some of the caramelization that I might miss in not doing a decoction. I am doing a 90' boil, so perhaps there'd be enough from that alone.
If you are looking for a darker brew I would use a higher percentage of Munich. You don't say whose malts you are using but a German dark Munich like Weyermann Type II is a good choice for a base. The typical modern Festbiers are lighter in color and seem to use more pils and Vienna than Munich but I like the darker, richer more traditional style. I've done a lot of different malt ratios over the years and my favorite is 70% Munich II and 30% Pilsner.
__________________
BigEd is offline
methodbeer Likes This 
Reply With Quote Quick reply to this message
Old 09-29-2012, 04:55 PM   #8
Bashiba
Feedback Score: 0 reviews
Recipes 
 
Join Date: Feb 2010
Location: Clinton, IA
Posts: 201
Liked 2 Times on 2 Posts

Default

+1 need more Munich, I just did 50% with mine, and I think I should have maybe went a little higher. I like big Ed's 70/30 idea.

__________________
Bashiba is offline
 
Reply With Quote Quick reply to this message
Old 09-29-2012, 07:45 PM   #9
methodbeer
Feedback Score: 0 reviews
Recipes 
 
Join Date: Dec 2010
Location: Raleigh, NC
Posts: 17
Liked 2 Times on 2 Posts
Likes Given: 1

Default

Thanks again BigEd and Bashiba. I might try the ~70% Munich. It is Weyerman, but I'm not sure which one. It's 10L--I assume that's Munich II.

__________________
methodbeer is offline
 
Reply With Quote Quick reply to this message
Old 09-30-2012, 02:20 PM   #10
Poobah58
HBT_LIFETIMESUPPORTER.png
Feedback Score: 1 reviews
 
Poobah58's Avatar
Recipes 
 
Join Date: Jun 2007
Location: New Milford, CT
Posts: 2,262
Liked 57 Times on 50 Posts
Likes Given: 25

Default

I see nothing wrong with 4.3% crystal malt for an Octoberfest. Vienna lager...yes, Octoberfest...no. I'm a big fan of 60% Vienna, 30% Munich and 10% crystal. Doing it myself in November.
BJCP: German Vienna Malt (bulk), Munich malt, some crystal. Noble hops. High carbonate water (see Munich water profile). Decoction mashing often used.

__________________
Mead Lane Brewing
The liver is evil and must be punished
Poobah58 is offline
 
Reply With Quote Quick reply to this message
Reply



Quick Reply
Message:
Options
Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Almost time to brew a Märzen - Single infusion with melanoidin recipe critique gritmaster Recipes/Ingredients 0 02-03-2012 03:31 AM
Märzen recipe binkman Recipes/Ingredients 5 03-04-2011 03:13 PM
First All Grain Recipe, thoughts? persianninja Recipes/Ingredients 3 11-11-2010 06:02 AM
1st all-grain IPA recipe... thoughts? riored4v Recipes/Ingredients 10 02-12-2009 01:53 PM
Thoughts on Recipe for First All Grain? Flipper Recipes/Ingredients 7 01-04-2008 02:57 AM



Newest Threads

LATEST SPONSOR DEALS