Originally Posted by icebob
Just bit the bullet and order one.... Would you mind telling/pics of how you got it setup?
did you buy just the module or the complete stand? i just bough one module without the stand.
i think i had to buy a stainless steel T to put the temperature probe into. they provide a threaded bushing that goes into the T and the probe threads into that bushing. once you get the bushing in it's pretty hard to get back out so if it leaks you have to find a way to get it back out or order another bushing ($5 i think, i did buy a spare). use a good, thick teflon tape on the bushing before threading into the stainless T, very important. blichmann says NOT to use teflon tape on the sensor threads, it has a silicon O ring that seals tight against the bushing. as far as the module there isn't much to do but set the temperature, hit enter then start recirculating.
this is what mine looks like. i pump from the mash tun though the lower pump fitting then up to the top of the mash tun where i have a lok line fitted to the inside of the tun.