 |
06-22-2007, 06:36 PM
|
#1
|
|
Senior Member
Join Date: Apr 2007
Posts: 2,017
|
Stainless Steel Washers Take 2
|
|
I Seem to have gotten myself into a familiar predicament, Only way I could get 5/8 SS washers was to buy bulk. Price is good, but many many more than I need. Soooooo (this is where it gets familiar) If anyone wants some, PM me and I'll give ya my address. Send me a buck and 2 are your to enjoy.
|
|
|
|
06-22-2007, 06:41 PM
|
#2
|
|
Senior Member
Join Date: Aug 2006
Location: Piscataway, NJ
Posts: 19,415
|
And you're using these for 3/8" pipe nipple bulkheads?
__________________
BrewHardware.com
Sightglass, Refractometer, Ball Valve, Weldless bulkhead, Thermometer, Decals, Stainless Steel Fittings, Compression Fittings, Camlock Quick Disconnects, Scale, RIMS tube, Plate Chiller, Chugger Pump, Super Clear Silicone Tubing, and more!
Personal Website, All Grain Primer, Keg Polishing, etc... | Youtube Channel
|
|
|
|
|
06-22-2007, 06:56 PM
|
#3
|
|
Senior Member
Join Date: Apr 2007
Posts: 2,017
|
Yes. They are for the 3/8 fittings on a mash tun. I used galvanized when I built it, and the rust has finally got too much for me to bare!!! Used it like that for years, but had to break down and redo it with SS.
|
|
|
|
|
06-22-2007, 07:02 PM
|
#4
|
|
Senior Member
Join Date: Aug 2006
Location: Piscataway, NJ
Posts: 19,415
|
I found 3/4" ones for 1/2" nipples at Lowes. Since I batch sparge, the bigger the bulkhead, the better. Hopefully enough folks here want to go with 3/8" that they'll clean out your bulk.
__________________
BrewHardware.com
Sightglass, Refractometer, Ball Valve, Weldless bulkhead, Thermometer, Decals, Stainless Steel Fittings, Compression Fittings, Camlock Quick Disconnects, Scale, RIMS tube, Plate Chiller, Chugger Pump, Super Clear Silicone Tubing, and more!
Personal Website, All Grain Primer, Keg Polishing, etc... | Youtube Channel
|
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
|
|
