plantnerd

Recipes 

I am looking for opinions on the viability of this as a 2nd primary fermentor. We have them on clearance at work, and since beginning brewing, it clicked that I might be able to use this for a larger primary. I have calculated a 10 gal. capacity based on my measurements, but am looking for ideas as to what to do with the two holes placed on the side of the unit. I guess I could get an airlock in the top, but what do you think about the bottom hole?

Janx

Recipes 

You could put a faucet in it to make racking a piece of cake.

Is that thing food grade?

__________________
Oh don't give me none more of that Old Janx Spirit
No, don't you give me none more of that Old Janx Spirit
For my head will fly, my tongue will lie, my eyes will fry and I may die
Won't you pour me one more of that sinful Old Janx Spirit

uglygoat

Recipes 

glass is what i'd get for a primary.

__________________
A barrel of malt, a bushel of hops, you stir it around with a stick
The kind of lubrication to make your engine tick

never argue with an idiot, they'll just drag you down to their level and beat you with experience.

plantnerd

Recipes 

It's the same grade of plastic as the plastic primary I am currently using. I have thought about putting a faucet valve in for racking.

Does anyone see problems with putting the airlock off to one side, as opposed to being in the center of the lid? I guess I could drill a hole in the lid and grommet it, but with the hole already there...

I would really love to go glass for the primary, but the funds are not here right now, and this is essentially free, so I thought I would give it a shot.

Janx

Recipes 

Airlock to the side is no big deal other than it's a little lower on the fermenter, so if your batch is big enough, it will be a bit more likely to blow off. You'll have to rig some sort of right-angle plug for it so the airlock sits upright.

__________________
Oh don't give me none more of that Old Janx Spirit
No, don't you give me none more of that Old Janx Spirit
For my head will fly, my tongue will lie, my eyes will fry and I may die
Won't you pour me one more of that sinful Old Janx Spirit

plantnerd

Recipes 

I was thinking a PVC 90 elbow, with male threads on one side. I figured I could fit a stopper into the other end, and put my airlock in there. Think I could place another elbow on the inside with a standpipe of sorts up closer to the top? That would leg gasses escape as well, and allow for more fermentation room.

Janx

Recipes 

Yeah that sounds awesome. Are those holes already conveniently threaded for you?

__________________
Oh don't give me none more of that Old Janx Spirit
No, don't you give me none more of that Old Janx Spirit
For my head will fly, my tongue will lie, my eyes will fry and I may die
Won't you pour me one more of that sinful Old Janx Spirit

plantnerd

Recipes 

Unfortunately, the holes are not threaded for me, but a 1" PVC fitting with threads DOES fit quite nicely. I figure if I get some sort of grommet to seal it off, I'll be good to go.

jeffbones

Recipes 

Is the inside smooth? The reason I ask is because on pond and aquarium filters a rough surface is good. You want more area for bacteria to grow.

plantnerd

Recipes 

The inside is smooth. The container is intended to be a biological filter, and is currently filled with "biomedia" which are plastic pieces about the size of a tennis ball, with a large amount of surface area, but the container itself is smooth inside and out.