A lathe with a face plate or the 4 jaw chuck to machine out the odd shaped pump body not drive it was my intent. You must be an attorney with twisting wording around. I can't believe some of these replies at times, sorry not picking on you just had to answer back. I would use a 90 VDC motor with a speed control, a Von Weise Gear Company I had in mind for motors. I have a 1/30 HP motor that runs off 120 VAC with speed controler to the 90 VDC motor. The parallel drive gearbox output on the 5/16" shaft is controlled from 18 to 114 rpm's. I can not stop it without trying to damage it with a 10" Cresent wrench on the output shaft.
A made in Missouri company. This motor is slated for the HLT stir propeller and another for the pump when I build one later.
__________________
Bier Jagdwaffe... Bier 30 zeit.....~~=o&o>..........
|
Linear Mode
