Home Brew Forums

Home Brew Forums (http://www.homebrewtalk.com/forum.php)
-   Equipment/Sanitation (http://www.homebrewtalk.com/f11/)
-   -   Low Pressure Regulator Question (http://www.homebrewtalk.com/f11/low-pressure-regulator-question-333544/)

yeqmaster 06-06-2012 06:56 AM

Low Pressure Regulator Question
1 Attachment(s)

Hi All-

I am in the works of building a new brew system/stand. I am going the low pressure route with Honeywell VR8200's for BK, MT & HLT. I am planning on having a common low pressure header and then splitting off for the 3 burners w/ individual isolation valves, VR8200's, flex hose and orifice/control valve.

The drawing I attached is similar but slightly different than what I am thinking now:

To feed the header, I was thinking about using this:

Has anybody had experience with it? Will it supply enough gas for 2 burners at once? Anybody know the BTU rating on it?

Do you think this is a good route to go or should I use a standard high pressure regulator and feed that to a Marshall 299-00?

Opionions on the matter would be much appreciated.

All times are GMT. The time now is 06:36 PM.

Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.