voodoochild7

Recipes 

Just got a corona grain mill as my friend was giving it away. How do I ajust this thing it seems the grain is getting too pulveized or not enough. Do the screws on the side have anything to do with the adjustment or should I just tighten those all the way and use only the center adjuster? Thanks

__________________
Chuck

Primary 1: Imperial Stout
Primary 2: Golden Ale
Keg 1: Nothing
Keg 2: Nothing

Baron von BeeGee

Recipes 

There should be a nut on the outside of the rotor that will move the rotor in or out as compared to the stator. Noonan recommends a gap of .035" so I used spark plug gauges to set mine and haven't had any issues with stuck sparges.

voodoochild7

Recipes 

Mine is the type with two clamps on either side that holde the stater with the center adjusting screw it seems that there is always one side with a gap greater that the other any tips on getting this thing close to home will be much appreciated

__________________
Chuck

Primary 1: Imperial Stout
Primary 2: Golden Ale
Keg 1: Nothing
Keg 2: Nothing