I'm using the 12v one....works amazing for how small it is. I use it to recirc the water in my HEX. But I read that its not rated above 120f(I think,if I recall correctly) so I mounted a bulkhead fitting to drain the HEX into the pump, then back into the other side of the HEX.
I'm using the 12v one....works amazing for how small it is. I use it to recirc the water in my HEX. But I read that its not rated above 120f(I think,if I recall correctly) so I mounted a bulkhead fitting to drain the HEX into the pump, then back into the other side of the HEX.
It looks like it says that it is rated for 100° Celsius. Should be good to go for anything we want to do.
I'm using the 12v one....works amazing for how small it is. I use it to recirc the water in my HEX. But I read that its not rated above 120f(I think,if I recall correctly) so I mounted a bulkhead fitting to drain the HEX into the pump, then back into the other side of the HEX.
Yeah you may be thinking of a different on that they sell.
__________________ Undefined Brewing Company - Beer for Undefined Drinkers
Do you think I could use this to transfer water from my brew kettle up and inside my igloo cooler? Wasnt sure if it was limited as far as how high it could move liquids.
Do you think I could use this to transfer water from my brew kettle up and inside my igloo cooler? Wasnt sure if it was limited as far as how high it could move liquids.
Are we talking about the same pump? I was looking at the 108 GPH model.
Just found the specs that say Cut-off: 3.5M (10ft) @12V.
I am assuming this is the lift? So 10 ft.?
Linear Mode
.gif-1367621329.gif)
