superbob404

Recipes 

Can I use an adjustable high pressure regulator for the BG12 burner? Then can I just get a valve to regulate the flame on each burner independently? Has anyone ever used copper for the gas line on your brew rig? Some people say the pipe can breakdown & clog the burner, others say they use it underground because it 'flexes' some instead of breaking. I think some copper pipe running up a stainless rig would look cool, any ideas?

Rondacker

Recipes 

As for copper, there isn't a problem. Propane installations here in the northeast have been piped in soft copper with flare fittings for as long as I can remember.
The only issue with something getting into the burner would be a bit of copper or dirt from the initial installation.
As for the regulator, just be sure that it isn't adjusted too high. Excessive pressure could cause the flame to lift too far off the tip of the orifice or burner.
There is normally a slight gap between the burner and the flame, excessive pressure increases the gap, and could result in a flame out, and raw gas venting.

__________________
Ein Bier, Bitte!

On Deck= Witt
Brewing=
Primary= Ed Wort's Apple Wine,
Secondary= Air
Bottled= Lots of Beer
Drinking= 2013 Maple Sap Ale, Columb-MO SMaSH IPA, Brando O's Graff.